New Yankee Workshop Episode 9907

In this episode, building a bake center, Norm used the following tools:

• Angle Wright A30 miter gauge
• Bessey K-Body clamps
• Bessey GH clamp
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamp
• Bosch 1584 jig saw
• Chisels
• Claw hammer
• Combination square
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 43-188 sliding shaper jig
• Lamello Dosicol glue bottle
• Leigh dovetail jig
• Porter-Cable 314 trim saw
• Porter-Cable 552 pocket hole machine
• Porter-Cable 557 biscuit joiner
• Porter-Cable 693 router
• Porter-Cable 862 cordless drill
• Porter-Cable 733x random orbit sander
• Porter-Cable BN200 brad nailer
• Porter-Cable cornering chisel
• Porter-Cable Laser-Loc miter saw
• Router table (shop built)
• Speed square
• Timesavers wide belt sander
• Tru-Grip clamp
• Unisaw
• Unifence
• Insert, melamine
• Insert, oak insert
• Utility knife

Items in bold represent the first appearance of that particular tool.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

The safety speech included video of a crosscut operation on the radial arm saw.

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.