New Yankee Workshop Episode 9906

In this episode, building a laundry center, Norm used the following tools:

• Angle Wright A30 miter gauge
• Bessey K-Body clamps
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Bosch 1584 jig saw
• Combination square
• Confirmat screws
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta DJ-20 jointer
• Freud EB-100 edge bander
• Framing Square
• Freud SD608 adjustable dado set
• Heat gun
• J-roller
• Lamello Top 20 biscuit joiner
• Melamine trimmer
• Porter-Cable 314 trim saw
• Porter-Cable 552 pocket hole machine
• Porter-Cable 691 router
• Porter-Cable 693 router
• Porter-Cable 7539 router
• Porter-Cable 862 cordless drill
• Porter-Cable large router edge guide
• Senco SLP20 brad nailer
• Speed square
• Timesavers wide belt sander
• Tru-Grip clamp
• Unisaw
• Unifence
• Insert, melamine
• Insert, oak insert
• Utility knife

Items in bold represent the first appearance of that particular tool.

Norm gave a close up look and explanation of his new Freud adjustable dado set.

In this episode, Norm made a point of having unplugged the saw while installing the dado set, and showed us plugging it back in.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

There was no stock video overlay during the safety speech. I don't recall that in any other episode (at least up to this one) since the safety speeches started in the second season.

Norm advised a dust or particulate mask to cut down on airborne particles.

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.