New Yankee Workshop Episode 9905

In this episode, building a teak bar, Norm also built a shutter mortising jig and used the following tools:

• Angle Wright A30 miter gauge
• Bessey K-Body clamps
• Bessey GH clamp
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Bosch 1584 jig saw
• Claw hammer
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 14-650 mortiser
• Delta 17-900 drill press
• Delta 28-280 band saw
• Delta 34-182 tenoning jig
• Delta 34-895 miter gauge
• Delta DJ-20 jointer
• Framing Square
• Lamello Top 20 biscuit joiner
• Leigh dovetail jig
• MEG shelf pin jig
• Porter-Cable 314 trim saw
• Porter-Cable 347 circular saw
• Porter-Cable 691 router
• Porter-Cable 693 router
• Porter-Cable 862 cordless drill
• Roller glue bottle
• Router table (shop built)
• Senco SLP20 brad nailer
• Spring clamp
• Timesavers wide belt sander
• Tru-Grip clamp
• Unisaw
• Unifence
• Insert, melamine
• Insert, oak insert
• Insert, red

An infrequent no-new-tool episode.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

The safety speech included video of a crosscut operation on the radial arm saw.

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.