New Yankee Workshop Episode 112

In this episode, building a writing desk, Norm used the following tools:

• Back saw, brass backed
• Bench chisel
• Bessey Tradesman clamps
• Biesemeyer T-Square
• Bosch 1272 belt sander
• Bostich T-31 brad nailer
• Bostich N60FN finish nailer
• C-clamps
• Claw hammer
• Cornering chisel
• Craftsman radial arm saw
• Dado blade (two blade wobble)
• Dado insert
• Dead blow hammer
• Drill-n-Drive bits
• Elu drill
• Elu router
• Framing square
• Hand screw clamps
• Jorgenson 37xx F-type bar clamp
• Jorgensen pipe clamps
• Makita 2114C bandsaw
• Makita 3601 D-handle router
• Makita router edge guide
• Makita 6095 cordless drill
• Makita 6402 drill
• Makita 2401B miter saw
• Panel cutting jig
• Porter-Cable 100 router
• Rockwell 5008 dovetail jig
• ShopSmith belt sanding station
• Shopsmith drillpress
• Shopsmith mortising attachment
• Spring clamps
• Taper jig
• Unisaw
• Original fence
• Original insert
• Original miter gauge
• Yankee screwdriver

Throughout Season One, a warning chyron appeared on screen concerning the use of a blade guard when operating a table saw.

Items in bold represent the first appearance of that particular tool.

One of the pipe clamps used was not a Jorgensen. It looked like a Sears, of which I used to have about a half dozen.

Field trip was to Hancock-Clarke House in Lexington, Massachusetts.

This episode was processed based on the full length original broadcast by PBS.