New Yankee Workshop Episode 111

In this episode, building a hutch, Norm used the following tools:

• Biesemeyer T-Square
• Black & Decker 7450 belt sander
• C-clamps
• Claw hammer
• Craftsman radial arm saw
• Dado blade (two blade wobble)
• Dado insert
• Dead blow hammer
• Elu cordless drill
• Elu drill
• Elu jig saw
• Elu router
• Framing square
• Jorgensen pipe clamps
• Jorgenson 37xx F-type bar clamp
• Makita 3601 D-handle router
• Makita router edge guide
• Makita 6019 cordless drill
• Makita 6095 cordless drill
• Makita BO4510 pad sander
• Makita 2401B miter saw
• Molding head (on radial arm saw)
• Panel cutting jig
• Pocket hole guide, single block
• Porter-Cable 100 router
• Porter-Cable router table
• Rockwell jointer
• Rockwell 5008 dovetail jig
• Unisaw
• Original fence
• Original insert
• Original miter gauge

Throughout Season One, a warning chyron appeared on screen concerning the use of a blade guard when operating a table saw.

This was the first episode in which not a single new tool appeared.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

Field trip was to Old Sturbridge Village, Massachusetts.

This episode was processed based on the full length original broadcast by PBS.