New Yankee Workshop Episode 1702

In this episode, building a bermuda bench/table, Norm used the following tools:

• Bessey K-Body clamps
• Bessey Tradesman clamps
• Biesemeyer auxiliary fence (short)
• Biesemeyer fence
• Chisels
• Claw hammer
• Combination square
• Dead blow hammer
• Delta 17-925 drill press
• Delta 28-280 band saw
• Delta 46-745 lathe
• Delta DJ-20 jointer
• Jack Rabbit driver
• Kugihiki Japanese flush cutting saw
• Lamello Top 20 biscuit joiner
• Lamello Dosicol glue bottle
• Osborne miter gauge
• Plug cutter
• Porter-Cable 121 oscillating spindle sander
• Porter-Cable 330 pad sander
• Porter-Cable 691 router
• Porter-Cable 7529 router
• Porter-Cable 9543 jig saw
• Porter-Cable 98xx cordless drill
• Roller glue bottle
• Router table (shop built) new
• Senco SLP20 brad nailer
• Spring clamp
• Star oscillating spindle sander
• Tru-Grip clamp
• Try square
• Unisaw
• Insert, oak insert

Norm built a simple jig to rout a wide dovetail in the uprights to receive a cross piece.

The combination square was in evidence but wasn't actually demonstrated.

Some old tool friends showed up today that we haven't seen in a while: P-C 330 sander, Dosicol glue bottle, plug cutter.

A new video to accompany the safety speech was shown today. It was an operation on the router table with a very wide panel—it actually looked like the top for this project.

Field trip to Historical Society Museum, St. Georges, Bermuda.

Project filmed 20, 23 April 2004.

This episode was processed based on the original broadcast by PBS.