New Yankee Workshop Episode 0102

In this episode, building jigs (part two of a two part project), Norm built the following jigs:

• shelf pin jig for router
• box joint jig for table saw
• circle cutting base plate for router
• shutter mortising jig for router
• hinge mortising jig for router

and used the following tools:

• Angle Wright A20 height gauge
• Angle Wright A30 miter gauge
• Bessey K-Body clamps
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamp
• Bevel gauge
• Biesemeyer T-Square
• Claw hammer
• Combination square
• Dado blade (stacked)
• Dado insert
• Delta 17-925 drill press
• Delta 28-280 band saw
• Delta 34-895 miter gauge
• Jack Rabbit driver
• MEG shelf pin jig
• Porter-Cable 42234 cornering chisel
• Porter-Cable 42700 edge guide
• Porter-Cable 693 router
• Porter-Cable 7529 router
• Porter-Cable 862 cordless drill
• Porter-Cable Laser-Loc miter saw
• Senco SLP20 brad nailer
• Spring clamp
• Tru-Grip clamp
• Unisaw
• Unifence
• Insert, oak insert
• Wonder bar

Items in bold represent the first appearance of that particular tool.

The MEG jig was in view and is clearly the genesis of the shelf pin jig, but it wasn't actually demonstrated in this episode.

The AngleWright A20 height gauge was also in view and was clearly used, but it wasn't actually demonstrated in this episode.

The safety speech included video of an operation on the router table (finger slip).

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.