New Yankee Workshop Episode 1213

In this episode, building a breakfront cabinet, Norm used the following tools:

• Angle Wright A30 miter gauge
• Bessey K-Body clamps
• Bessey GH clamp
• Bessey GRZ Super-Grip clamp
• Bosch 1584 jig saw
• Chisels
• Claw hammer
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 43-188 sliding shaper jig
• Jack Rabbit driver
• Leigh dovetail jig
• Lion trimmer
• Porter-Cable 691 router
• Porter-Cable 693 router
• Porter-Cable 7529 router
• Porter-Cable 862 cordless drill
• Router table (shop built)
• Senco SLP20 brad nailer
• Shelf pin jig, shop made (simplified version of the one pictured in the link)
• Speed square
• Tru-Grip clamp
• Unisaw
• Unifence
• Insert, melamine dado
• Insert, oak insert
• Insert, red

An infrequent no-new-tool episode.

Norm introduced sanding sponges in this episode. Frankly, I don't recall noticing him use them in later episodes, so I won't bother to make a tool page about them.

Norm used a plain board clamped to the Unifence as a sacrificial fence.

The safety speech included video of an operation on the router table (finger slip).

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.