New Yankee Workshop Episode 9807

In this episode, building a cupola, Norm used the following tools:

• Bessey GH clamp
• Biesemeyer T-Square
• Claw hammer
• Dado blade (stacked)
• Dead blow hammer
• Delta 28-280 band saw
• Delta 33-890 12" radial arm saw
• Delta 34-895 miter gauge
• Delta DJ-15 jointer
• Drill 'n Drive bits
• Handsaw
• Lamello Top 20 biscuit joiner
• Panel jig
• Porter-Cable 347 circular saw
• Porter-Cable 853 cordless drill
• Porter-Cable 862 cordless drill
• Porter-Cable FN250 finish nailer
• Porter-Cable Laser-Loc miter saw
• Senco SLP20 brad nailer
• Unisaw
• Unifence
• Insert red

Items in bold represent the first appearance of that particular tool.

The P-C 853 with Drill 'n Drive chucked up were seen laying next to the frame and clearly were needed for a succeeding step but were not actually demonstrated.

Norm demonstrated a technique of resawing a miter joint with a handsaw to tighten the joint.

At the end of this episode Norm had a friend of Morash productions, Larry Stearns, of Vulcan Supply come in to build a copper roof for the cupola. All sorts of copper fabricating techniques were demonstrated, including bending sheets on a serious industrial brake.

The safety speech included video of a crosscut operation on the radial arm saw.

Field trip was to the then current This Old House project, Milton, Massachusetts.

This episode was processed based on the full length original broadcast by PBS.