New Yankee Workshop Episode 809

In this episode, building three turned table lamps, Norm used the following tools:

• Awl
• Bessey K-Body clamps
• Bessey Tradesman clamp
• Husqvarna chainsaw
• Center finder
• Chisels
• Dead blow hammer
• Delta 17-900 drill press
• Delta 28-280 band saw
• Delta 33-890 12" radial arm saw
• Delta DL-40 lathe
• Hitachi CB75F resaw band saw
• Porter-Cable 2620 drill
• Porter-Cable 840 cordless drill
• Speed square
• Unisaw
• Unifence
• Utility knife

Items in bold represent the first appearance of that particular tool.

The view of the Husqvarna chainsaw was so fleeting that I wasn't able to identify it positively until Norm used it again six years later in Episode 1410.

Norm used three! adhesives in these projects—his regular yellow PVA glue, his newly found polyurethane glue, and an epoxy.

The safety speech included video of a crosscut operation on the radial arm saw.

Norm included hearing protection in his safety advisory. Good thing—the chainsaw was the tool next to be used.

Field trip was to The Yankee Craftsman salvage shop, Wayland, Massachusetts.

This episode was processed based on the full length original posted on The New Yankee Workshop website. Duration 24′ 41″