New Yankee Workshop Episode 1909

In this episode, demonstrating table saws, (part two of a two part project) Norm used the following tools:

• Bessey Kliklamp
• Biesemeyer auxiliary fence (long)
• Biesemeyer auxiliary fence (short)
• Biesemeyer fence
• Combination square
• Claw hammer
• Dado blade (both wobble and stacked)
• Dado insert
• Dead blow hammer
• Delta 28-280 band saw
• Delta 34-184 tenoning jig
• Delta 34-895 miter gauge
• Delta 36-71x hybrid saw
• Framing square
• Jack Rabbit driver
• Osborne miter gauge
• Panel cutting jig, new
• Porter-Cable 314 trim saw
• Porter-Cable 691 router
• Porter-Cable 7529 router
• Porter-Cable 98xx cordless drill
• Saw Aid™ push stick, etc.
• Tru-Grip clamp
• Unisaw
• Insert, red
• Insert, oak insert

Items in bold represent the first appearance of that particular tool.

The 34-895 miter gauge, long auxiliary fence, wobble dado, and both P-C routers were shown but not actually demonstrated.

The safety speech included video of an operation on the router table (wide board).

No field trip.

Project filmed 18, 19, 20 July 2006.

This episode was processed based on the full length original broadcast by PBS.