New Yankee Workshop Episode 305

In this episode, building a Shaker wall clock, Norm used the following tools:

• Bessey K-Body clamps
• Biesemeyer fence
• Biesemeyer T-Square
• Bosch 1584 jig saw
• Bostich T-31
• "C" clamp
• Chisels
• Combination square
• Commercial Feather Board
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 17-900 drill press
• Delta 17-935 mortising attachment
• Delta 34-172 tenoning jig
• Elu drill
• Hot melt glue gun
• Jorgensen pipe clamps
• Jorgenson 37xx F-type bar clamp
• Lion trimmer
• Makita planer
• Makita 3601 D-handle router
• Makita 2401B miter saw
• Porter-Cable 691 router
• Porter-Cable 696 router table
• Raised panel jig for table saw (shop made)
• Rockwell jointer
• Speed square
• Spring clamp
• Tru-Grip clamp
• Unisaw
• Insert, melamine

An unusual no-new-tool episode.

Norm used a plain board screwed to the Biesemeyer as a sacrificial fence.

The safety speech included video of a ripping operation with a push stick.

Field trip was to Hancock Shaker Village, Pittsfield, Massachusetts.

This episode was processed based on a broadcast by HGTV.