New Yankee Workshop Episode 1606

In this episode, building a dower chest, Norm used the following tools:

• Bessey GRZ Super-Grip clamp
• Bessey K-Body clamps
• Bessey KLI Klamp
• Bessey Tradesman clamps
• Biesemeyer auxiliary fence (long)
• Biesemeyer fence
• Bosch 1584 jig saw
• Chisels
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 17-925 drill press
• Delta 22-580 planer
• Delta DJ-20 jointer
• Dowel-it jig
• Hot melt glue gun
• Kugihiki Japanese flush cutting saw
• Lamello Top 20 biscuit joiner
• Lamello Dosicol glue bottle
• Leigh dovetail jig
• Panel cutting jig, new
• Porter-Cable 352 belt sander
• Porter-Cable 42700 edge guide
• Porter-Cable 691 router
• Porter-Cable 693 router
• Porter-Cable 7529 router
• Porter-Cable 98xx cordless drill
• Porter-Cable PIN100 pin nailer
• Roller glue bottle
• Router table (shop built) new
• Senco SLP20 brad nailer
• Star oscillating spindle sander
• Unisaw
• Insert, oak insert

Once again, although the Dosicol glue bottle was in sight and clearly had been used, it wasn't actually observed being used.

On the other hand, although he mentioned using a spring clamp, we didn't actually see Norm use it, nor was it seen, so I didn't list it here.

Decorative painting by Natalie Gardner, who also did the Pier Table (Episode 1610) and the Taunton Chest (Episode 1910).

The safety speech included video of an operation on the router table (finger slip).

Field trip was to Winterthur, near Wilmington, Delaware.

Project filmed 24, 25 June 2003.

This episode was processed based on the original broadcast by PBS.