New Yankee Workshop Episode 911

In this episode, building a greenhouse (part one of a two part project), Norm used the following tools:

• Angle Wright A30 miter gauge
• Bessey K-Body clamps
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Biesemeyer T-square fence
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 17-900 drill press
• Delta 28-280 bandsaw
• Delta 33-890 12" radial arm saw
• Delta DJ-15 jointer
• Drill 'n Drive bits
• Hand saw
• Hitachi cordless impact wrench
• Porter-Cable 2620 drill
• Porter-Cable 314 trim saw
• Porter-Cable 347 circular saw
• Porter-Cable 840 cordless drill
• Porter-Cable 853 cordless drill
• Porter-Cable 7564 ½" drill
• Porter-Cable Laser-Loc miter saw
• Senco SLP20 brad nailer
• Sledge
• Speed square
• Unifence
• Unisaw
• Insert red
• Insert, oak insert

Norm used a plain board clamped to the Unifence as a sacrificial fence.

Norm seemed to have a touch of laryngitis in this project (both 911 and 912). I remember he had a bad case on a This Old House episode once, but I can't remember the project. I wonder if it was the same time frame?

The safety speech included video of a crosscut operation on the radial arm saw—oblique view.

Field trip was to the greenhouse of a friend—probably Morash—Lexington, Massachusetts.

This episode was processed based on the full length original broadcast by PBS.