New Yankee Workshop Episode 1613

In this episode, building a gardener's dry sink, Norm used the following tools:

• Bessey GRZ Super-Grip clamp
• Bessey K-Body clamps
• Bessey Tradesman clamps
• Biesemeyer auxiliary fence (long)
• Biesemeyer auxiliary fence (short)
• Biesemeyer fence
• Claw hammer
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 14-650 mortiser
• Delta 34-182 tenoning jig
• Delta 36-255 laser chop saw
• Framing Square
• Jack Rabbit driver
• Kreg mini pocket hole jig
• Kreg pocket hole jig clamp
• Kugihiki Japanese flush cutting saw
• Lamello Top 20 biscuit joiner
• Leigh dovetail jig
• Osborne miter gauge
• Plug cutter
• Porter-Cable 121 oscillating spindle sander
• Porter-Cable 42700 edge guide
• Porter-Cable 691 router
• Porter-Cable 693 router
• Porter-Cable 7529 router
• Porter-Cable 98xx cordless drill
• Porter-Cable PIN100 pin nailer
• Router table (shop built) new
• Senco SLP20 brad nailer
• Try square
• Unisaw
• Insert, melamine
• Insert, oak insert
• Utility knife

In all the years Norm has been using the Bessey K-Body clamps, he has always had clamps long enough for his projects. Today, he used some back-to-back to extend the reach, but he never discussed the technique!

For the only time I can recall since the safety speech began, there was no associated video—just a head shot of Norm talking the talk.

Field trip was to a designer showcase put on by the Junior League of Boston, Massachusetts.

Project filmed 2, 3, 4 December 2003.

This episode was processed based on the original broadcast by PBS.