New Yankee Workshop Episode 1401

In this episode, building a miter bench (part one of a two part project), Norm used the following tools:

• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Biesemeyer fence
• Biesemeyer auxiliary fence (short)
• Biesemeyer auxiliary fence (long)
• Bosch 1584 jig saw
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 14-650 mortiser
• Delta 33-890 12" radial arm saw
• Jack Rabbit driver
• Jorgenson 37xx F-type bar clamp
• Lamello Top 20 biscuit joiner
• Osborne miter gauge
• Porter-Cable 310 laminate trimmer
• Porter-Cable 314 trim saw
• Porter-Cable 691 router
• Porter-Cable 7529 router
• Porter-Cable 862 cordless drill
• Porter-Cable OmniJig
• Porter-Cable 9837 Cordless Reciprocating Saw
• Senco SFN40 finish nailer
• Senco SLP20 brad nailer
• Tru-Grip clamp
• Unisaw
• Insert red

Items in bold represent the first appearance of that particular tool.

The 14-650 mortiser was in view and clearly integral to the planning of the project, but it wasn't actually demonstrated in this episode.

While Norm frequently demonstrates checking for square of frames, drawers, and other assemblies, he doesn't often show what to do if the item is out of square. In this episode, he did.

The safety speech included video of an operation on the router table (finger slip).

No field trip this episode.

This episode was processed based on the full length original broadcast by PBS.