New Yankee Workshop Episode 1507

In this episode, building a media press (part one of a two part project), Norm used the following tools:

• Bessey K-Body clamps
• Bessey GRZ Super-Grip clamp
• Bessey Tradesman clamps
• Biesemeyer fence
• Biesemeyer auxiliary fence (long)
• Dado blade (stacked)
• Dado insert
• Dead blow hammer
• Delta 17-925 drill press
• Delta 28-280 band saw
• Delta 34-895 miter gauge
• Dewalt 965 right angle cordless
• Lamello Top 20 biscuit joiner
• Jack Rabbit driver
• Osborne miter gauge
• Porter-Cable 552 pocket hole mach
• Porter-Cable 9543 jig saw
• Porter-Cable 98xx cordless drill
• Router table (shop built) new
• Senco SLP20 brad nailer
• Spring clamp
• Try square
• Unisaw
• Insert, melamine
• Insert, oak insert
• Insert, red
• Williams & Hussey molder

An infrequent no-new-tool episode.

Norm made much of leveling the dust frames before nailing into them from the back panel.

We were introduced to vintage sawtooth and cleat adjustable shelves.

The safety speech included video of an operation on the router table (finger slip).

Field trip was to Jeff Jenkins at Leonard's Antiques, Seekonk, Massachusetts.

This episode was processed based on the full length original broadcast by PBS.